Omega DP6000 User Manual page 97

DP6000 Process Meter
Display Parameter
Input Input
Latching
LatCH
LED test
LED t
Length
Length
Linear
Linear
Max on little
Lit Hi
display
Max/min little
Lit HL
display
Min on little
Lit Lo
display
Little Little display
locd Locked
Lt-CLr Latching-cleared
mA 4-20 mA
Manual
mAn
Maximum
mAx
Modbus
mbus
Menu button
menu
Minimum
min
Number of points
No PtS
Relays output
O Hold
hold
OFF Off
OFF 1 Off 1
On On
Action/Setting Description
Enter Input selection menu
Set relay for latching operation
Test all LEDs
Enter the tank's length in inches
Set meter for linear function and select
number of linearization points
Assign digital input to display max on the
small display
Assign digital input to toggle max/min on the
small display
Assign digital input to display min on the small
display
Press Enter to assign the small display
parameter (default: engineering units)
Enter password to unlock meter
Set relay for latching operation with manual
reset only after alarm condition has cleared
Set meter for 4-20 mA input
Press Enter to manually control relays or
analog output operation
Program maximum mA output allowed
Select to display Modbus input or to assign
Modbus input as the analog output source
Assign digital input to Menu button
Program minimum mA output allowed
Set meter for 2 to 32-point linearization
Assign digital input to hold all relays state
Disable relay and front panel status LED, turn
relays off, program off time delay
Set relay 1 Off time delay (1-8)
Enable fail-safe operation, turn relays on,
program on time delay
97
Instruction Manual