Rear Panel - Chroma 19020 Quick Start Manual

Multi-Channel Sync Hipot Tester 19020/19020-4/19021/19022/19022-4

3.2 Rear Panel

This section introduces the rear panel.
(1) GPIB Interface (optional): This is the connector of optional GPIB interface
(2) RS232 Interface
(3) CAN BUS Interface : This connector is used for data communication
(4) Terminal Resistance Selector : This DIP switch is used to set the terminal
(5) INTER LOCK
(6) HANDLER Interface: This is the connector for HANDLER interface. See
(7) Internal Communication Interface: This connector is used for control signal
(8) Fuse Holder
card under IEEE-488-1978 standard. See Multi-
Channel Sync Hipot Tester 19020/19020-4/19021/
19022/19022-4 User's Manual in the CD for detail
usage.
: This is the connector of optional RS232 interface card.
GPIB and RS232 cannot be used at the same time.
between MASTER and SLAVE.
resistance for CAN BUS interface. It is necessary to
set the DIP switch to ON for the first and last Testers on
the CAN BUS transmission path.
: High voltage can only be outputted when these two
terminals are short-circuited.
Multi-Channel Sync Hipot Tester 19020/19020-4/
19021/19022/19022-4 User's Manual in the CD for
detail usage.
transmission between MASTER and SLAVE.
: See Chapter 2
Precaution before Use
specification or the label mark on the rear panel.
Quick Start Guide
for detail
11