Overtightening fasteners can damage the Terreon material. Use caution when tightening bowl and sprayhead fasteners. ® Product warranties may be found in the “Products” section on our Web site at bradleycorp.com. Bradley Corporation • 215-1498 Rev. F; ECM 11-08-011 10/24/11...
³⁄₈" bolts and 1" min. O.D. washers, two places. Do not overtighten. Tighten the pan-head screws Do not overtighten. Bradley Corporation • 215-1498 Rev. F; ECM 11-08-011 10/24/11 SCUFF BASE FRAME AND DRAIN ASSEMBLY NOT SHOWN FOR CLARITY...
Page 8
Loosen but do not remove the two mounting screws holding the valve bracket to the frame. Slide the valve bracket up and lift it from the frame. Attach the stop to the tempered wall stub-out. Bradley Corporation • 215-1498 Rev. F; ECM 11-08-011 10/24/11...
Page 9
Connect the ½" flexible the solenoid valve assembly. hose from the cold water supply stub-out to the hot water heater inlet. Bradley Corporation • 215-1498 Rev. F; ECM 11-08-011 10/24/11...
Page 10
Reinstall the valve bracket. Turn on the water supply to the Express and check for leaks. Push the operating buttons of each ® station until all the air is purged from the lines and water is flowing smoothly. Reinstall the access panel. Bradley Corporation • 215-1498 Rev. F; ECM 11-08-011 10/24/11...
2. Clean valve seat and inspect for deep gouges or scratches. Replace valve body if necessary. 3. Remove any debris clogging off-center hole in rubber diaphragm. Bradley Corporation • 215-1498 Rev. F; ECM 11-08-011 10/24/11...
Check Valve* 132-051 Retaining Ring* 118-319 Valve Body 146-079 U-Clip * Included with Prepack S65-326 Tempered Line Adapter Option Part no. S39-804 (replaces S59-4000 if tempered line is used) Strainer (173-028) Bradley Corporation • 215-1498 Rev. F; ECM 11-08-011 10/24/11...
Avoid contact with hot pans and objects. Repair Kits: Terreon repair kits are available. Contact your Bradley representative or distributor for part numbers and pricing. Repair kits are made to order and have a shelf life of 30 days.
To change soap, pour out all of the soap from the dispenser ans rinse with hot water several times until all residue is removed. Pump the valve until clean water appears. Rinse the dispenser with ethyl alcohol; air dry before refilling. Bradley Corporation • 215-1498 Rev. F; ECM 11-08-011 10/24/11...
Need help?
Do you have a question about the Express SS-2N/AST-WH and is the answer not in the manual?
Questions and answers