Table of Contents
Advertisement
Status and troubleshooting via LED on the MotorController
11
In the event of failure/error of the MotorController one or more diodes will light and/or blink.
On the WCC 106 there are 4 diodes - 3 green and 1 yellow - that can indicate errors and status on the MotorController.
Irrespective which diode lights or blinks, the indicator is based on a 3.2 second sequence that is repeated continuously. Each
sequence is defined by 32 x 0.1 second time segments.
If there are several errors on the MotorController simultaneously they are displayed by priority, i.e. error messages for the most
critical failures are shown first and repeated until the failure is remedied. Then error number two is shown, which likewise is
repeated until the error is remedied etc. The following overview shows the most frequently occurring errors, if an error other than
those listed below is indicated, contact WindowMaster.
Yellow diode – LED 1
If the yellow diode lights, this indicates an error on the MotorController.
Black = diode off
Error indicator on the yellow diode is a total errors indicator. Detailed information on the error type can be decoded on the green
diode.
Green diode – LED 2
If the green diode LED 2 (closest to X10) blinks, this indicates the error on the MotorController.
Black = diode off
Green diode – LED 3
The green diode LED 3 (furthest away from X8) indicates status of or error on the motor line #2.
Black = diode off
14
Advertisement
Table of Contents
