Supermicro SuperServer SYS-110P-WTR-EU User Manual page 59

LAN Port Enable/Disable
Use JPL1 to enable or disable LAN port 1 and JPL2 to enable or disable LAN port 2. These
two jumpers are available on X12SPW-F. Use JPL3 to enable or disable LAN ports 1 and 2.
This jumper is available on X12SPW-TF
ME Manufacturing Mode
Close pins 2-3 of jumper JPME1 to bypass SPI flash security and force the system to operate
in the manufacturing mode, which will allow the user to flash the system firmware from a
host server for system setting modifications. Refer to the table below for jumper settings.
The default setting is Normal.
LAN Port Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
Manufacturing Mode
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal
Pins 2-3 Manufacturing Mode
59
Chapter 4: Motherboard Connections