Supermicro SuperServer SYS-110P-WTR-EU User Manual page 53

TPM/Port 80 Header
A Trusted Platform Module (TPM)/Port 80 header is located at JTPM1 to provide TPM support
and Port 80 connection. Use this header to enhance system performance and data security.
Refer to the table below for pin definitions. Please go to the following link for more information
on the TPM: http://www.supermicro.com/manuals/other/TPM.pdf.
Standby Power
The Standby Power header is located at JSTBY1 on the motherboard. You must have a card
with a Standby Power connector and a cable to use this feature. Refer to the table below
for pin definitions.
4-pin BMC External I
2
A system Management Bus header for IPMI 2.0 is located at JIPMB1. Connect the approriate
cable here to use the IPMB I
definitions.
Trusted Platform Module Header
Pin Definitions
Pin# Definition Pin#
1 +3.3V 2
3 RESET# 4
5 SPI_CLK 6
7 SPI_MOSI 8
9 +3.3V Stdby 10
Standby Power
Pin Definitions
Pin# Definition
1 +5V Standby
2 Ground
3 No Connection
C Header
C connection on your system. Refer to the table below for pin
2
External I C Header
2
Pin Definitions
Pin# Definition
1 Data
2 Ground
3 Clock
4 P3V3 STBY
53
Chapter 4: Motherboard Connections
Definition
SPI_CS#
SPI_MISO
GND
NC
SPI_IRQ#