Table of Contents
Advertisement
Examples
# Create an S-channel on Ten-GigabitEthernet 1/0/1, with the SCID 10 and SVID 5.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] evb s-channel 10 service-vlan 5
# Create an S-channel on Bridge-Aggregation 1, with the SCID 10 and SVID 5.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] evb s-channel 10 service-vlan 5
Related commands
evb enable
•
•
interface
evb vdp timer keepalive exponent
Use evb vdp timer keepalive exponent to configure a VDP keepalive exponent.
Use undo evb vdp timer keepalive exponent to restore the default.
Syntax
evb vdp timer keepalive exponent value
undo evb vdp timer keepalive exponent
Default
The VDP keepalive exponent is 20.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
Parameters
value: Specifies a VDP keepalive exponent in the range of 14 to 31.
Usage guidelines
The value for VDP keepalive time is expressed by the following equation:
VDP keepalive time (seconds) = 1.5 × [ 2
] × 10
retransmission
For detailed values, see
Table 7
uses 3 and 16 (the defaults) as the ECP maximum retransmission time and the ECP retransmission
exponent to calculate the VDP keepalive time. These two variables use the larger values proposed by the
station and bridge through EVB TLV.
The network environment and configurations on the EVB bridge and station determine whether to use the
defaults or the actual proposed values for the following ECP values:
ECP maximum retransmission time.
•
ECP retransmission exponent.
•
5
—
Table
7.
+ (2 × ECP maximum retransmission time + 1) × 2
VDP keepalive
17
ECP
Advertisement
Table of Contents
