Interface - HPE S5830V2 Series Command Reference Manual

When a filter configured on a VSI interface contains information about a VLAN, you must not
•
configure the filter on the same VSI interface again or on other VSI interfaces of the S-channel
interface. Otherwise, an error message appears.
• If the VSI filter is a set of VID values, and the MAC address learning function for the corresponding
S-channel is disabled, traffic for the VSI cannot be forwarded.
Activate a VSI interface after configuring a VSI filter, and deactivate a VSI interface before removing
•
a VSI filter.
When you configure VSI filters on a VSI aggregate interface, follow these guidelines:
Before you configure a VSI filter on a VSI aggregate interface, make sure the S-channel aggregate
•
interface to which the VSI aggregate interface belongs operates in trunk mode. Otherwise, the VSI
filter configuration fails.
After you configure a VSI filter on a VSI aggregate interface, an S-channel aggregate interface
•
automatically permits the VLAN that is configured in the VSI filter for the subordinate VSI aggregate
interface. The same rule takes effect on Layer 2 aggregate interfaces associated with S-channels.
• After you delete a VSI filter that contains information about a VLAN on a VSI aggregate interface,
if other VSI filters on all VSI aggregate interfaces of an S-channel aggregate interface do not
contain the VLAN, the S-channel aggregate interface automatically denies traffic from the VLAN
that is configured on the VSI filter. The same rule takes effect on Layer 2 aggregate interfaces
associated with S-channels.
When a filter configured on a VSI aggregate interface contains information about a VLAN, you
•
must not configure the filter on the same VSI aggregate interface again or on other VSI aggregate
interfaces of the S-channel aggregate interface. Otherwise, an error message appears.
• Activate a VSI aggregate interface after configuring a VSI filter, and deactivate a VSI aggregate
interface before removing a VSI filter.
Examples
# Configure a VSI filter for VLAN 1 on the VSI interface S-Channel 1/0/1:10.1.
<Sysname> system-view
[Sysname] interface s-channel 1/0/1:10.1
[Sysname–S-Channel1/0/1:10.1] evb vsi filter vlan 1
# Configure a VSI filter for VLAN 1 on the VSI aggregate interface Schannel-Aggregation 1:10.1.
<Sysname> system-view
[Sysname] interface schannel-aggregation 1:10.1
[Sysname–Schannel-Aggregation1:10.1] evb vsi filter vlan 1
Related commands
evb mac-learning forbidden
•
• evb vsi active

interface

Use interface to enter S-channel interface view, S-channel aggregate interface view, VSI interface view,
or VSI aggregate interface view.
Syntax
interface
interface-number:channel-id.vsi-local-id }
{ s-channel | schannel-aggregation
23
} { interface-number:channel-id |