Trill Enable; Trill Evb-Support - HPE FlexFabric 5930 Series Command Reference Manual

trill enable

Use trill enable to enable TRILL on a port.
Use undo trill enable to disable TRILL on a port.
Syntax
trill enable
undo trill enable
Default
TRILL is disabled on a port.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
Usage guidelines
To enable TRILL on a port, first enable TRILL globally.
Enable or disable TRILL on all ports in a VLAN, so that the ports in a VLAN have the same TRILL
status (enabled or disabled).
Do not enable both TRILL and EVB on a port. If the trill evb-support command is not executed on
an EVB-enabled port, make sure the allowed VLANs of the port do not overlap with those of a
TRILL-enabled port. For more information about EVB, see EVB Configuration Guide.
Do not enable the spanning tree protocol on a TRILL port. Because the spanning tree protocol is
enabled by default on all ports, the spanning tree feature takes effect on all ports when you enable
the spanning tree feature globally. After the spanning tree protocol is enabled globally, you must
disable the spanning tree feature on TRILL ports. For more information about the spanning tree
feature, see Layer 2—LAN Switching Configuration Guide.
Configuration in Layer 2 Ethernet interface view takes effect only on the current port. Configuration in
Layer 2 aggregate interface view takes effect on the current interface and its member ports.
Configuration on the member port of an aggregate interface takes effect after the member port
leaves the aggregation group.
Examples
# Enable TRILL globally, and enable TRILL on port FortyGigE 1/0/1.
<Sysname> system-view
[Sysname] trill
[Sysname-trill] quit
[Sysname] interface fortygige 1/0/1
[Sysname-FortyGigE1/0/1] trill enable
Related commands
trill

trill evb-support

Use trill evb-support to enable TRILL to forward traffic from EVB S-channels.
Use undo trill evb-support to restore the default.
47