RANGER AIR 260MPX
®
AIR COMPRESSOR CONNECTIONS
WARNING
•
Before starting, performing maintenance or
replacing parts, relieve the entire system
pressure.
•
Turn the machine off and wait at least
1 minute.
•
Remove pressure from attached air devices - hoses,
storage tanks, tools,etc.
SLOWLY to make sure all pressure has been
relieved.
•
Compressors generate heat and create hot surfaces.
Use caution when operating and servicing equipment.
Some surfaces and components may be hot.
Air hoses must have a minimum working pressure of 350 psi
and a minimum burst pressure of 1400 psi. Use hoses with at
Use only Vanair genuine Vanguard™ oil. Check the oil level
daily before starting the machine.
NOTE: Operating the compressor with oil other than Vanair's
ganuine Vanguard™ oil may cause compressor damage and
over temperature conditions. Incorrect oil usage may void
compressor warranty.
Included with the Ranger Air is a #8 Male SAE/ORB to #8
Male JIC fitting.
Belt
Coalescing
Filter
Sight
t
Glass
NOTE: Third Air Connection point (unshaded yellow arrow
above) is located on the bottom of the Ranger Air.
A-10
INSTALLATION
Oil Filter
Ai C C
Air Connections
t