Install The Cover Or Secure The Rear Door; Add The Drive To A Partition; Restart Backups - Spectra Logic T-Series Spectra T200 Install Manual

Install the Cover or Secure the Rear Door

Spectra T200 or T380 Replace the protective cover after you complete the installation.
1. Lift the cover and align it so that the two nuts extending from the back of the cover
fit into the corresponding holes on either side of the chassis
to the drives and QIPs installed in the library are routed from the:
top of the library, make sure that they fit into the cutout in the top of the cover.
bottom of the library, make sure that they fit into the cutout in the bottom of the
cover.
Caution
2. Using your fingers or a #2 Phillips screwdriver, tighten the two screws to secure the
bottom of the cover to the chassis (see
Spectra T680 Close and lock the protective door on the back of the library rack (see
Figure 8 on page 15).
Spectra T950 Close and lock the protective doors on the back of the library (see
Figure 9 on page 16).

Add the Drive to a Partition

New drive—If you installed an additional (new) drive, you need to add it to a
partition before you can begin using it for backup operations. Refer to the Spectra
T200, T380, T680 User Guide or the Spectra T950 User Guide for instructions.
Replacement drive—If you replaced a drive, the new drive is automatically added
to the partition of the old drive.

Restart Backups

Use your backup software to restart any backup processes that had been running to
the replaced drive. This restart ensures that the software recognizes the drive as
working and available.
22
Make sure that cables are not pinched between the cover and
the chassis.
Figure 6 on page 15).
(Figure 7). If the cables