Table of Contents
Advertisement
40) The usage of a license plate support
on the front bumper may affect the proper
radar unit functionality. When using a
license plate support, follow the markings
and indications on the front bumper
41) The use of mats or pedals covers not
approved by Jeep may interfere with the
operation of the speed limiter or cruise
control. To avoid any risk of jamming the
pedals ensure that the mat is secured
correctly and never fit one mat on top of
another.
WARNING
11) The operation of the radar(s), along
with any associated functions, may be
affected by the accumulation of dirt (e.g.
mud, ice), in poor weather conditions
(e.g. heavy rain, snow), or if the bumpers
are damaged. If the front bumper is to
be repainted, contact a Jeep Dealership;
certain types of paint could interfere with
the operation of the radar(s).
16
12) This camera and its associated
functions may be impaired or not work if
the windscreen area in front of the camera
is dirty, misty, frosty, covered with snow,
damaged or masked by a sticker. In humid
and cold weather, demist the windscreen
regularly. Poor visibility (inadequate street
lighting, heavy rain, thick fog, snowfall),
dazzle (headlamps of an oncoming
vehicle, low sun, reflections on a damp
road, leaving a tunnel, alternating shade
and light) can also impair detection
performance. In the event of a windscreen
replacement, contact a Jeep Dealership
to recalibrate the camera; otherwise, the
operation of the associated driving aids may
be disrupted.
13) The images from the camera(s)
displayed on the touch screen or on the
instrument panel may be distorted by
the terrain. In the presence of areas in
shade, or in conditions of bright sunlight
or inadequate lighting, the image may
be darkened and with lower contrast.
Obstacles may appear further away than
they actually are.
14) The operation of the sensors, as well as
any associated functions, may be disrupted
by noise pollution such as that emitted by
noisy vehicles and machinery (e.g. lorries,
pneumatic drills), by the accumulation of
snow or dead leaves on the road or in the
event of damaged bumpers and mirrors.
When reverse gear is engaged, an audible
signal (long beep) indicates that the
sensors may be dirty. A front or rear impact
to the vehicle can upset the sensors'
settings, which is not always detected
by the system: distance measurements
may be distorted. The sensors do not
systematically detect obstacles that are too
low (pavements, studs) or too thin (trees,
posts, wire fences). Certain obstacles
located in the sensors' blind spots may not
be detected or may no longer be detected
during the manoeuvre. Certain materials
(fabrics) absorb sound waves: pedestrians
may not be detected.
15) Clean the bumpers and door mirrors
and the field of vision of the cameras
regularly. When washing your vehicle at
high pressure, direct the spray from at least
30 cm away from the radar, sensors and
cameras.
PARKING
42) 43)
16)
Advertisement
Table of Contents
