Harmonic Enhancer Control Depth; Damping; Damping Control Change Number; Damping Control Depth - Yamaha MU100R Owner's Manual

Multi Edit Mode

Harmonic Enhancer Control Depth

(HrmCtrlDpt)
Settings: -64 — +63
Sets the amount of variation produced by
the controller assigned to the harmonic
enhancer. The higher the value, the greater
the variation. Positive values cause an
increase in harmonic enhancer depth in
response to higher controller values (e.g.,
increased breath pressure or higher modu-
lation wheel position), while negative
values cause a decrease in harmonic en-
hancer depth in response to higher con-
troller values.

Damping

Damping Control Change Number

(Dmp CC No.)
Settings: off, 01 — 31, off, 33 — 95,
AT, VEL, PB
"Damping" simulates the effect of damp-
ing due to losses within the body of a wind
instrument or in a string due to air fric-
tion. This affects both pitch and timbre.
The "Dmp CC No." parameter specifies
the controller to be used for damping con-
trol. When set to "off," no damping varia-
tion can be applied via a controller.
Details
• Note that accurate keyboard pitch is pro-
duced only when damping is maximum.
• The "DmpCtrlDpt" parameter (below) must
be set to an appropriate value (higher than
"+01" or lower than "-01") for damping
control to have any effect.
124
Damping Control Depth (DmpCtrlDpt)
Settings:
Sets the amount of variation produced by
the controller assigned to damping. The
higher the value, the greater the variation.
Positive values cause a decrease in damp-
ing in response to higher controller val-
ues (e.g., increased breath pressure or
higher modulation wheel position), while
negative values cause an increase in
damping in response to higher controller
values.

Absorption

Apsorption Control Change Number
(Abs CC No.)
Settings:
"Absorption" simulates the effect of high-
frequency loss at the end of the air col-
umn or string. The "Abs CC No." param-
eter specifies the controller to be used for
absorption control. When set to "off," no
absorption variation can be applied via a
controller.
Details
• Note that accurate keyboard pitch is pro-
duced only at when absorption is maxi-
mum.
• The "AbsCtrlDpt" parameter (below) must
be set to an appropriate value (higher than
"+01" or lower than "-01") for absorption
control to have any effect.
Multi Mode
-64 — +63
off, 01 — 31, off, 33 — 95,
AT, VEL, PB