Embouchure Control Depth; Tonguing; Tonguing Control Change Number; Tonguing Control Depth - Yamaha MU100R Owner's Manual

Embouchure Control Depth (EmbCtrlDpt)
Settings: -64 — +63
Sets the amount of variation produced by
the controller assigned to embouchure.
The higher the value the greater the varia-
tion. Positive values cause an increase in
embouchure in response to higher con-
troller values (e.g., increased breath pres-
sure or higher modulation wheel posi-
tion), while negative values cause an de-
crease in embouchure in response to
higher controller values.

Tonguing

Tonguing Control Change Number

(Tng CC No.)
Settings: off, 01 — 31, off, 33 — 95,
AT, VEL, PB
"Tonguing" simulates the half-tonguing
technique used by saxophone players by
changing the "slit" of the reed. The slit is
the space between the tip of the reed and
the mouthpiece. The "Tng CC No." pa-
rameter specifies the controller to be used
for tonguing control. When set to "off"
no tonguing is applied.
Details
• Note that accurate keyboard pitch is pro-
duced only when maximum tonguing is ap-
plied or the tonguing controller is turned
off.
• The "TngCtrlDpt" parameter (below) must
be set to an appropriate value (higher than
"+01" or lower than "-01") for tonguing
control to have any effect.
Tonguing Control Depth (TngCtrlDpt)
Settings:
Sets the amount of variation produced by
the controller assigned to tonguing. The
higher the value, the greater the variation.
Positive values cause an decrease in
tonguing in response to higher controller
values (e.g., increased breath pressure or
higher modulation wheel position), while
negative values cause an increase in
tonguing in response to higher controller
values.

Scream

Scream Control Change Number

(Scr CC No.)
Settings:
"Scream" drives the entire system into
chaotic oscillation, creating effects that
can only be achieved with physical mod-
eling technology. The "Scr CC No." pa-
rameter specifies the controller to be used
for scream control. When set to "off", no
scream variation can be produced via a
controller, but a continuous scream value
is determined by the "ScrCtrlDpt" param-
eter below. (Negative values increase the
scream level.)
Details
• The "ScrCtrlDpt" parameter (below) must
be set to an appropriate value (higher than
"+01" or lower than "-01") for scream con-
trol to have any effect.
Multi Mode
Multi Edit Mode
-64 — +63
off, 01 — 31, off, 33 — 95,
AT, VEL, PB
121