Using A Comfort Hand Control; Correcting The Height Display - LOGICDATA SMARTneo-3G Operating Manual

To Delete a Container or Shelf Stop Position:
1. Press the UP or DOWN Key to move the Table Top to the top half (to delete a Shelf
Stop Position) or bottom half (Container Stop Position) of the movement area.
2. Press and hold the UP Key and DOWN Key for 10 seconds.
▸ The Container Stop / Shelf Stop Position is deleted (Container Stop if you are
in the bottom half of the movement area, Shelf Stop if you are in the top half).

8.4.2 USING A COMFORT HAND CONTROL

To Save a Container Stop or Shelf Stop Position:
1. Press the UP or DOWN Key to move the Table Top to the desired position.
2. Press and hold the SAVE Key for 10 seconds.
▸ The Control Box will click twice.
▸ The Container Stop / Shelf Stop Position is saved.
To Delete a Container or Shelf Stop Position:
1. Press the UP or DOWN Key to move the Table Top to the top half (to delete a Shelf
Stop Position) or bottom half (Container Stop Position) of the movement area.
2. Press and hold the SAVE Key for 10 seconds.
▸ The Control Box will click once.
▸ The Container Stop / Shelf Stop Position is deleted.

8.5 CORRECTING THE HEIGHT DISPLAY

This feature changes the height displayed on the Hand Control. It does not affect the table's actual height.
1. Press the SAVE Key.
S -
▸ The display shows S –.
2. Press and hold the DOWN Key for approximately 5 seconds.
▸ The display starts to flash.
▸ Use the UP Key or DOWN Key to set the new height.
SMARTNEO OPERATING MANUAL // PAGE 28