Dynamic Ip Address Setting; Factory Default Reset - 2N Indoor Talk User Manual

NOTE
The following network parameters will be set after restart:
• IP address: 192.168.1.100
• Network mask: 255.255.255.0
• Default gateway: 192.168.1.1

Dynamic IP Address Setting

Follow the instructions below to switch on the Static IP address mode (DCHP ON):
1. Press and hold the RESET button.
2. Wait until the red and green LEDs go on simultaneously on the device and the acoustic signal can be
heard (approx. 15–35 s).
3. Wait until the red LED goes off and the acoustic signal can be heard
4. Wait until the green LED goes off and the red LED goes on again and the acoustic signal can be heard
(approx. for another 3 s).
5. Release the RESET button.

Factory Default Reset

Follow the instructions below 2N Indoor Talk to reset the factory default values:
1. Press and hold the RESET button.
2. Wait until the red and green LEDs go on simultaneously on the device and the acoustic signal can be
heard (approx. 15–35 s).
3. Wait until the red LED goes off and the acoustic signal can be heard
4. Wait until the green LED goes off and the red LED goes on again and the acoustic signal can be heard
(approx. for another 3 s).
5. Wait until the red LED goes off and the acoustic signal can be heard
6. Release the RESET button.
Configuration
24
(approx. for another 3 s).
(approx. for another 3 s).
(approx. for another 3 s).