Yamaha 03D Owner's Manual page 26

D
INSERTs (input channels 1 and 2)
These TRS phone jack connectors are used to connect signal processors for use with
input channels 1 and 2 exclusively. Typically, compressors, limiters, and noise gates are
connected to this type of connection. They are wired: sleeve–ground, ring–return,
tip–send.
Tip (send)
Ring (return)
1/4" TRS phone plug
Sleeve (ground)
Connect to INSERT jack
E
ST IN
These balanced phone jack inputs, with a
nominal input range of –20 dB to +10 dB,
are the inputs to the stereo input channel.
Either balanced or unbalanced phone plugs
can be connected. The stereo outputs of an
external effects processor or other stereo
device can be connected here.
F
INPUTs 9–16
Input channels 9–16 feature balanced
phone jack connectors with a nominal
input range of –20 to +10 dB. Either bal-
anced or unbalanced phone plugs can be
connected. These inputs are best suited for
line-level signals.
G
MONITOR OUT
These are balanced 1/4-inch phone jacks
with a +4 dB nominal output level. Either
balanced or unbalanced phone plugs can be
connected. They output the monitor sig-
nals and should be connected to the inputs
on a monitor amplifier. The monitor signal
source is determined by the MONITOR
OUT SOLO/2TR IN switch. The output level is set using the MONITOR LEVEL con-
trol.
H
BUS OUTs
These are balanced 1/4-inch phone jacks
with a +4 dB nominal output level. Either
balanced or unbalanced phone plugs can be
connected. They output the bus signals and
can be connected to multitrack recorders,
power amplifiers, and so on.
Rear Panel
1/4" phone plug
To processor's input
Sleeve (ground)
1/4" phone plug
From processor's output
Sleeve (ground)
1/4" TRS phone plug
Ring (cold)
Sleeve (ground)
1/4" TRS phone plug
Ring (cold)
Sleeve (ground)
1/4" TRS phone plug
Ring (cold)
Sleeve (ground)
1/4" TRS phone plug
Ring (cold)
Sleeve (ground)
03D—Owner's Manual
17
Tip (send)
Tip (return)
Tip (hot)
Tip (hot)
Tip (hot)
Tip (hot)