Yamaha 03D Owner's Manual page 143

DYNA.PHASER
Parameter Range
SENSE 0–100
FB.GAIN –99 to +99%
OFFSET 0–100
1
HOLD
2
DECAY
DIR Up, Down
LSF F 21 Hz–1.0 kHz
LSF G –12 to +12 dB
STAGE 2–16
HSF F 500 Hz–16 kHz
HSF G –12 to +12 dB
1. 0.02 ms–2.13 s fs=32 kHz/44.1 kHz, 0.02 ms–1.96 s fs=48 kHz
2. 6 ms–46.0 s fs=32 kHz/44.1 kHz, 5 ms–42.3 s fs=48 kHz
FREEZE (Effect 2 only)
Parameter Range
REC MODE MANUAL, INP TRG
–1000 to +1000
REC. DLY
ms
TRG. LVL – , –60–0 dB
1
PLY MODE
TRG MASK 0–999.6 ms
MIDI TRG OFF, C1–C6, ALL
LOOP
0–100
NUM
2
START
2
END
2
LOOP
PITCH –12 to +12
FINE –50 to +50 cent
1. MOMENT, CONTINUE, INP TRG
2. 0–131070 samples (0.0–2730.6 ms fs=48 kHz, 0.0 ms–2972.1 ms fs=44.1 kHz,
0.0–4095.9 ms fs=32 kHz).
To record a sample, select the REC READY switch, and then press the [ENTER] button.
The REC READY switch appears highlighted, indicating that the effect is now ready to
record. If the REC MODE is set to MANUAL, press the [ENTER] button to start
recording. If REC MODE is set to INP TRG, recording starts automatically when the
input signal exceeds the TRG LEVEL.
Description
Input sensitivity.
Feedback amount.
Offset of the phase shift point.
Hold time.
Delay time.
Select whether the phase shift point will move upward (Up)
or downward (Down) in response to a high input level.
Frequency of the low shelving filter.
Gain of the low shelving filter.
Number of stages of phase shift.
Frequency of the high shelving filter.
Gain of the high shelving filter.
Description
Select the recording mode. MANUAL: recording is started
by the [ENTER] button. INP TRG: recording is triggered by
the input signal.
Specify the time difference between the trigger time and
when recording actually begins. Affects recording only.
Specify the level of the input trigger.
Select the playback mode. MOMENT: playback will occur
while the [ENTER] button is pressed. CONTINUE: playback
will occur the specified number of times when the [ENTER]
button is pressed. INP TRG: same, but triggered by the
input signal.
Specify the time from when triggering occurs until the next
trigger can be accepted. Affects playback only.
Make settings for triggering via MIDI note-on/off messages.
Only the specified note will trigger.
Specify the number of times that playback will be looped.
Specify the point at which playback will begin.
Specify the point at which playback will end. If looping is
used, this will be the repeat point.
Specify the start of the loop.
Specify the change in playback pitch in semitone steps.
Specify a fine adjustment in 1-cent steps to the playback
pitch.
141
Effects Parameters
03D—Owner's Manual