Yamaha 03D Owner's Manual page 85

80
Chapter 7—Solo, Monitors & Meters
3. Use the cursor buttons to select the PEAK HOLD switch, and then press
the [ENTER] button to activate the peak hold function.
If you are using a mouse, simply click the PEAK HOLD switch.
PEAK HOLD —This switch is used to turn on and off the Peak Hold function for the
Meter pages and the L STEREO R meters. When Peak Hold is ON, the meter segments
lit by the loudest signal peaks remain on, providing an easy way to check for peak levels.
To turn these meter segments off, set the PEAK HOLD switch to OFF. When the meter
mode is changed, the Peak Hold function is reset. Peak Hold for the Solo and stereo
meters is not affected.
The PEAK HOLD switch also appears on the CH 17–24, and YGDAI meter pages.
The following CH 17–24 meter page contains level meters for input channels 17 to 24,
the aux sends, and the bus outs. The stereo input channel and effects returns 1 and 2
meters also appear on this page. The decibel value below each meter indicates the posi-
tion of the corresponding channel fader. The position of the stereo out fader appears in
the ST OUT LEVEL box.
The following YGDAI Out meter page contains level meters for the eight YGDAI out-
puts and Solo bus. The boxes below the YGDAI output meters show which signals are
assigned to the YGDAI outputs. See Assigning Signals to the YGDAI Outputs on page
224 for more information. When the meter mode is set to GAIN REDUCTION, peak
hold for the XGDAI output meters is reset when the CH 1–16 or CH 17–24 meter page
is selected.
03D—Owner's Manual