Yamaha 03D Owner's Manual page 245

Programmable Mixer 01, 02R, 03D Pages
The same remote control functions are available for the Programmable Mixer 01, 02R,
and 03D. The following table lists the mixer parameters that can be controlled from the
03D.
03D Control
Channel faders
[ON] buttons
Display functions
1. Use the [MIDI REMOTE] button to locate the P.Mix01, 02R, or 03D page.
03D channel faders 1 to 16 correspond to faders 1 to 16 on the remote mixer. Adjusting
an 03D fader changes the corresponding fader on the remote mixer.
03D [ON] buttons 1 to 16 correspond to [ON] buttons 1 to 16 on the remote mixer.
Operating an 03D [ON] button mutes the corresponding channel on the remote mixer.
To adjust the pan on the remote mixer, select a pan control on the display and use the
PARAMETER wheel. The corresponding pan control on the remote mixer changes.
To recall a mix scene on the remote mixer, select the MEM NO. parameter and use the
PARAMETER wheel to choose a mix scene. The TITLE of the mix scene does not yet
appear. Select the RCL switch, and then press the [ENTER] button to recall the mix
scene on the remote mixer. The mix scene is recalled and the 03D's fader positions are
updated to reflect the remote mixer's new fader positions, and the pan controls on the
03D's display are updated to show the new pan positions. The 03D's [ON] button indi-
cators show the mute status of the remote mixer channels.
The Connect function can be used to update the 03D's fader positions, display pan con-
trols, and [ON] buttons to reflect those of the remote mixer when the remote mixer is
first connected or turned on. To execute the Connect function, select the CONNECT
switch, and then press the [ENTER] button.
If you are controlling a Programmable Mixer 01, set its Control Change Assign mode
to Register.
If you are controlling an 03D, make the following settings on its MIDI Setup page:
PROGRAM CHANGE RX= ON, PROGRAM CHANGE ECHO=OFF, CONTROL
CHANGE TX=OFF, CONTROL CHANGE ECHO=OFF, PARAMETER CHANGE TX
and RX both=ON, PARAMETER CHANGE ECHO=OFF, and BULK RX=ON. The
MIDI RX CH, MIDI TX CH and DEVICE NO. should match the Remote MIDI Chan-
nel number. So that the remote 03D doesn't affect the mix scene functions on the con-
trolling 03D, set CONTROL CHANGE RX=OFF on the controlling 03D.
Programmable Mixer 01, 02R, 03D Parameter
Channel faders
Channel ON/OFF
Pan
Mix scene recall
245
MIDI Remote
03D—Owner's Manual