Table of Contents
Advertisement
Operation
6-3. Copying selected frames
1.
(MANUAL COPY)
Play back the frame serving as the copy source.
Use direct search or other search method to play
back the frame serving as the copy source.
. Start manual copying.
When the REC button is pressed, the frame being
played is recorded onto the disc in the external
drive.
Other frames can be copied by repeating steps 1
and 2.
. Upon completion of the copying of the required
frames, open the menu again, and release the copy
mode.
6-4. Copying selected frames from multi
1.
screens (MANUAL COPY)
Press
the MULTI
button to initiate multi-screen
playback.
The same can be done when the unit is set to multi-
screen playback as a result of a search operation.
. Move
the selection
frame
on the multi-screen,
select the frame to be copied, and press the SET
button to play back the frame on the full screen.
. Start manual copying.
When the REC button is pressed, the frame being
played back on the full screen is recorded onto the
disc in the external drive.
. Press any button to return to the multi-screen.
Other frames can be copied by repeating steps 3
and 4.
. Upon completion of the copying of the required
frames, open the menu again, and release the copy
mode.
6-5. Automatically copying frames in
1.
program seguence (PROGRAM COPY)
Set the program playback sequence.
First, register the program playback sequence on
the PROGRAM setup menu.
2. Start program copying.
Press the REC button.
White program playback
proceeds, the frames are recorded onto the disc in
the external drive.
While program playback is underway, the settings
(interval time, VOICE playback, NEXT mode, etc.)
on the PLAY setup menu are disabled.
40
3. When program playback is completed, the copying
is terminated.
Press the CLR button to terminate copying at any
time.
6-6. Copying discs (DUPLICATE)
1. Start duplicate copying.
While the setup menu
is closed, press the REC
button.
The frames on the copy source disc are recorded
starting from address 1 onto the disc in the external
drive.
2. When all the frames on copy source disc have been
recorded,
the
duplicate
copying
operation
is
terminated.
Press the CLR button to terminate copying at any
time.
Cautions:
1. The SCSl-related settings (ID and terminator) and
the cable connections must be done while the
units power is Off.
Errors made in the settings or connections can
cause operating problems and failures.
„When the contents of a disc are duplicated, all the
data
on
the
copy
destination
disc
will
be
overwritten
and
erased.
Even
if the
copy
destination disc is a WRITE-ONCE disc, it will still
be overwritten and erased.
Check the disc before proceeding.
Advertisement
Table of Contents
