Table of Contents
Advertisement
Operation
< Concerning the INC function for IDs
|
3 When an ID setting is completed, press the SET
1) The only IDs which can be incremented are
button to close the ID setting screen
@
IDs consisting
of numerals
only or of a
If an ID is going to remain unchanged, press the ID
character string and numerals
In the latter
button (by pressing the "-" button while holding
case, only the numeral part ıs incremented
down the SHIFT button) to close the ID setting
2) The numerals-only IDs are incremented by
screen
carrying the digits
There
Is no carrying
beyond 15 digits since this is the maximum"
<Note>
number of digits
Using the DISC MANAGEMENT setup menu, it is also
There ıs no carrying for IDs consisting of a
"possible to write ID values for frames after the frames
character string and numerals
have been recorded
"Name" and "Name2" cannot be
(The
total
number
ot
ID
characters
is
recorded and set using the controls on the front panel
maintained )
or wired remote controller
3) With an ID consisting of a character string and
They are set from RS-232C
numerals, the character string must be to the
left of the numerals
IDs whose
character
string is to be right will not be incremented
Examples of ID incrementing are shown below
ec 000001234567890 > + < 000001234567891 > Incrementing for a numerals-only ID
» < 000000000009999 > + < 000000000010000 > Carrying for a numerals-only ID
* < 999999999999999 > — < 000000000000000 > Max of 15 digits
ex
ABC999 > = <
ABCO00 > ID consisting of a character string and numerals
ec
123ABC > + <
123ABC > This ID will not be incremented
ex
999 > = <
000 > If spaces are provided at the left, the ID is construed as
@
consisting of a character string and numerals
26
Advertisement
Table of Contents
