Table of Contents
Advertisement
Operation
2-2. Playing back frames automatically by
1.
N
specifying a time interval
(AUTO PLAY)
Set the playback operation mode.
Select the playback operation on the PLAY setup
menu.
PLAY MODE:
Select AUTO PLAY.
INTERVAL:
Set the playback time interval.
Refer to the cautions presented on the next
page.
STILL-MODE:
Set the playback frame output mode to field or
frame.
VOICE:
Select ON if the voice memo
is to be made
audible during frame playback.
Select OFF if the voice memo is not to be made
audible during frame playback.
REPEAT:
Select ON if repeat playback is to be performed.
Select OFF
if repeat playback is not to be
performed.
POWERON START:
Select ON for automatic playback when
the
power is turned on.
NEXT:
A setting
can
be selected
only when
the
component recording format is used for the unit
and disc.
Select ON if the next frame is to be
monitored (previewed) at the monitor output.
. Start the automatic playback.
Press the FORWARD
button.
The FORWARD
lamp flashes, and the frames in the sequence of
their addresses starting with the current playback
address (or the address recorded last immediately
after the power is turned on or address 1 when
ON is selected as the POWERON START setting)
are played back in the time interval set.
In the Component mode, the playback frame is
switched seamlessly.
When the playback time interval has been set to
less than
the voice
memo
playback
time
(5
seconds), the audio play will be cut short.
. End automatic playback.
Press the CLR button.
2-3. Playing back a program by specifying
a time interval (PROGRAM PLAY)
1. Set the program playback sequence.
First, register the program
playback sequence
using the PROGRAM setup menu. (See page 52.)
. Set the playback operation mode.
Select the playback operation on the PLAY setup
menu.
PLAY MODE:
Select PROGRAM PLAY.
INTERVAL:
Set the playback time interval.
Refer to the
cautions presented on the next page.
STILL-MODE:
Set the playback frame output mode to field or
frame.
VOICE:
Select ON if the voice memo
is to be made
audible during frame playback.
Select OFF if the voice memo is not to be made
audible during frame playback.
REPEAT:
Select ON if repeat playback is to be performed.
Select OFF
if repeat playback
is not to be
performed.
POWERON START:
Select ON for automatic
playback when
the
power is turned on.
NEXT:
A setting
can
be
selected
only when
the
component recording format is used for the unit
and disc.
Select ON if the next frame is to be monitored
(previewed) at the monitor output.
. Check the program sequence if necessary.
When
multi-screen
playback
is performed,
the
programs can be displayed on the multi screen in
the
program
sequence
so
that
the
program
playback sequence can be checked,
. Start program playback.
Press the FORWARD
button.
The FORWARD
lamp flashes during program playback.
Advertisement
Table of Contents
