Panasonic LQ-D100P Operating Instructions Manual page 68

Other i
2. Messages/error messages
Message displays fall into two categories: warning The main causes of errors are mistakes made in
displays which warn of mistakes made in operation, operation (remote control operations included), disc
and error displays which are caused by trouble inthe trouble and equipment trouble.
equipment, etc.
List of messages/error messages
UNFORMAT DISC Unformatted disc. Format the disc prior to use.
E-03 | WRITE-PROTECT DISC | Disc is write-protected: no recording is Disc Use a record-enable disc.
possible.
E-04 | WRITE-ONCE DISC An attempt was made to record in an Disc Po l
already recorded area on a pseudo write-
once disc.
The equipment mode (RGB or Component | Equipment, | Turn off the power, and set the equipment
mode) and the recording format of the disc | disc mode to correspond with the recording
do not match. format of the disc using the DIP switches
on the rear panel.
TOP OF DISC Top of disc Operation
PICTURE FORMAT
MISMATCH
E-07 | DISC FULL Frames have been recorded on all the Operation | Use a new disc.
areas on the disc.
NO MORE PICTURE No frames have been recorded in the Operation
addresses ahead.
NO PICTURE Not one frame has been recorded on the | Operation RI
disc.
E-10 | NO TARGET-PICTURE The target frame has not been selected
(played back).
Operation | This message appears in the process of
overwriting data when the frame which is
to overwrite another is not being played
back. Play back the target frame.
NO VOICE A voice memo has not been recorded Operation
NO PROGRAM DATA A program has not been registered Operation | First register the program, and then play it
back.
END OF PROGRAM Program playback has finished. Operation
E
E
PROGRAM ADDRESS lilegal program address Operation | First register the correct program address,
ERROR and then play the program back.
NO INPUT-SIGNAL No input signals have been supplied Operation | First connect the input signals, and then
repeat the operation.
INPUT ALREADY The INPUT mode has already been Operation
established.
NOT INPUT MODE The mode established for operation is not | Operation | Press the INPUT button to set the unit to
-11
-13
E-15
E-16
E-17
the INPUT mode. the INPUT mode. Then conduct the same
operation.
FREEZE ALREADY The FREEZE mode has already been Operation
established.
NOT FREEZE MODE The mode established for operation is not
the FREEZE mode.
Operation | Press the FREEZE button to set the unit
to the FREEZE mode. Then conduct the
same operation.
If the unit is set to the AUTO REC mode,
release the mode, and then conduct the
same operation.
OVERWRITE ERROR
The overwrite mode cannot be
established.
Operation
68