Table of Contents
Advertisement
Screen displays
7-2) Program LOAD and SAVE screens
Up to 20 sets of program data can be saved on a disc.
The program data which suits a particular purpose
can be saved on disc and then loaded for use as and
when required.
l
Programs are loaded from discs and saved onto
discs. Therefore, a disc must be inserted into the unit
for these operations.
,
,
l
The disc must be set to the write-enable status if data
is to be saved on it.
O LOAD
This operation serves to load the program data from
the disc into the unit.
When
the cursor is aligned with <LOAD>
on the
PROGRAM sub menu and the SET button is pressed,
the numbers of 20 programs on the disc are displayed
on the right side of the screen.
Use the up, down, left and right arrow buttons to
select the number of the program to be loaded from
among programs No.1 to No.20.
When a particular program number is selected, the
date and time at which that program was recorded on
the disc are displayed at the bottom of the screen.
in the figure below, for example,
it is clear that
program No.7 consists of data which was recorded at
10 hours 10 minutes 50 seconds on July 15, 1999.
Dashes will appear for the date and time display if the
number of the program selected has no program data
recorded.
When the required program number is selected and
the SET button is pressed, the program data is loaded
from the disc into the unit. Remember that if there is
any program data already inside the unit, it will be
overwritten.
< PROGRAM >
< PROGRAM-INPUT >
<
>
< SAVE >
< CLEAR >
9 PROGRAM- 19
10
PROGRAM- 20
(1999/07/15
10:10:50)
LOAD <SET> / END <MENU>
SELECT
<4?
4 Y>-
i> SAVE
This operation serves to save the program data inside
the unit onto the disc.
When
the cursor is aligned with <SAVE>
on the
PROGRAM sub menu and the SET button is pressed,
the numbers of 20 programs
(program write area
numbers) for saving data onto the disc are displayed
on the right side of the screen.
Use the up, down,
left and right arrow
buttons to
select the number of the program whose data is to be
saved from among programs No.1 to No.20.
When particular program number already saved is
selected, the date and time at which that program was
recorded on the disc are displayed at the bottom of
the screen,
Dashes will appear for the date and time display if the
number of the program selected has no program data
recorded.
When the required program number is selected and
the SET button is pressed, the program data is saved
from the unit onto the disc.
When the number of a program already saved is
selected and the SET button is pressed, the data in
that program will be overwritten.
< PROGRAM
>
< PROGRAN-INPUT >
< LOAD >
< ENA >
< CLEAR >
PROGRAN- 1
PROGRAM- 2 PROGRAM- 12
PROGRAM- 6
7 PROGRAM- 17
18
20
SELECT
<q> A Y>
SAVE <SET> / END <MENU>
54
Advertisement
Table of Contents
