Table of Contents
Advertisement
General Introduction
* The table below shows the correlation between the main output and monitor output. ("OSD" is short for on-
screen display.)
INPUT
Input frame
(OSD enabled)
"-
(OSD enabled)
| FREEZE
— ë | Freeze screen
(OSD enabled)
-
(OSD enabled)
Normal playback
——
mode
Ptayback
Playback (current frame)(OSD enabled)
"-
(OSD enabled)
E EMOS a eel
mode OFF)
[Seup[Seupmend
T
INPUT
Input frame
{OSD disabled)
"-
(OSD enabled)
| FREEZE
| Freeze screen
(OSD disabled)
—
(OSD enabled)
NEXT mode i
CO
O
sap mana
NEXT mode 2
3. Description of operation steps
The steps taken to use the NEXT mode are described
below.
1) Conditions for using the NEXT mode
2) During playback, the current frame is output to the
è The
equipment
mode
must
be set to the
main output connectors, and at the same time the
Component mode.
frame with the next address (next program frame
The "RGB MODE" DIP switch on the rear panel
during program playback) is read in advance as the
must be at OFF.
next
frame
and
output
to the
monitor
output
è Either NEXT mode 1 or 2 must be selected.
connector.
"NEXT 1/2" OFF setting of rear panel DIP switch
When the playback instruction is issued by the
= Mode 1
FORWARD button, the next frame is immediately
"NEXT 1/2" ON setting of rear panel DIP switch =
output to the main output connectors, and at the
Mode 2
same time the frame with the next address (next
è A disc with the component recording format must
program frame during program playback) is read
be used.
and output to the monitor output connector as the
è NEXT mode ON must be set using the PLAY
next frame.
setup menu item.
<Note>
As described above, the unit normally operates on the
assumption that the frame with the next address is the
next frame.
For
this
reason,
when
the
REVERSE
button
is
pressed, it will take some moments for the main
output to be switched.
12
Advertisement
Table of Contents
