Panasonic LQ-D100P Operating Instructions Manual page 30

Operation
2. Frame playback
When performing the playback operation from the
INPUT mode for the first time after the power was
turned on, the frame recorded last on the disc is
played back.
When, on subsequent occasions, a playback
operation is initiated from the INPUT or FREEZE
mode, the frame of address played previously is
played back (when, for instance, a playback operation
is performed again after the unit was set to the INPUT
mode from playback).
2-1. Playing back frames
1. Set the playback operation mode.
< PLAY >
INTERVAL
STILL-MODE
VOICE
REPEAT
POWERON START
NEXT
MULTI-SCREEN
SELECT <4P a Y> EXIT <MENU> / SAVE <SET>
Select the playback operation on the PLAY setup
menu.
PLAY MODE:
Select NORMAL.
INTERVAL:
When NORMAL is selected as the PLAY MODE
setting, the interval is canceled (--:--:--),
STILL MODE: .
Set the playback frame output mode to field or
frame.
VOICE:
Select ON if the voice memo is to be made
audible during frame playback.
Select OFF if the voice memo is not to be made
audible during frame playback.
REPEAT:
Select ON if repeat playback is to be performed.
Select OFF if repeat playback is not to be
performed.
NEXT:
A setting can be selected only when the
component recording format is used for the unit
and disc. Select ON if the next frame ts to be
monitored (previewed) at the monitor output.
30
2. Start playback.
Press the FORWARD or REVERSE button. The
lamp of the button pressed lights, and the frame is
played back.
Each time the FORWARD button is pressed, the
frame of the next higher address is played back;
conversely, each time the REVERSE button is
pressed, the frame of the next lower address is
played back. |
In the Component mode, the playback frame is
switched seamlessly.
In the NEXT mode, the next frame is output to the
monitor output connector.
When ON has been selected for the VOICE setting,
the voice memo is played back for about 5
seconds.