Table of Contents
Advertisement
Preparations
2. DIP switch settings
The DIP switches on the rear panel are set as shown
below.
Before attempting to change a DIP
switch
setting, be absolutely sure that the power has been
turned off.
| Swich no. |
Display
Default setting
Description of function
I
la
mig
BI
l
Kā
U
This is used to switch the unit's equipment mode to the RGB mode or
Component mode.
ON:
RGB mode
OFF: Component mode
This is used to inhibit all operations to record on the disc when it is set to ON.
It
is set when the unit is to be used as a playback-only unit.
ON:
Recording is inhibited.
OFF: Recording is permitted.
This is used to enable or disable the operation of the front buttons when the
LOCAL/REMOTE
switch on the front panel has been set to REMOTE.
ON:
Operation of the front buttons is enabled.
OFF: Operation of the front buttons is disabled.
<Note>
When this switch is set to ON, the front keys can be operated in the REMOTE
mode but since this imposes a heavier toll in terms of the system processing, the
response to the operation of the buttons, etc. may be impaired stightly.
It is recommended that this switch be used at the OFF setting unless use of the
front keys are required.
This is used to select mode 1 or mode 2 when the NEXT mode is set.
ON:
Mode 2
OFF:
Mode 1
This is used to set the SCSI terminating resistance (terminator) of the internal
drive to ON or OFF. Set it to OFF when an external drive is to be connected to
the SCSI connector.
ON:
Terminator is set to ON (an external drive is not connected).
OFF:
Terminator is set to OFF (an external drive is connected).
21
Advertisement
Table of Contents
