Grinding Cutting Tools (Sm-90) - Dick SM-100 Operating Instructions Manual

Operation

7.1.2 Grinding cutting tools (SM-90)

1
Figure 13 – Grinding a cutting tool
1
Figure 14 – Grinding a cutting tool
1. Clean the cutting tool before use.
2. Position the cutting tool on the machine so that the cutting tool cutting
edge [13-1] points in the direction of rotation of the lamellar grinding
wheel [13-2].
3. Align the cutting tool horizontally so that it is positioned roughly
perpendicular [13-3] to the lamellar grinding wheel.
4. Position the cutting tool blade [14-1] on the lamellar grinding wheel at an
angle of approx. 10° [14-2].
5. When grinding, grind the sides of the cutting tool alternately until a burr
has formed over the entire cutting edge.
[13-1]
3 [13-2]
[13-3]
2
[14-1]
[14-2]
2
Operating Instructions SM-90/-100/-100W
Cutting tool blade
Direction of rotation of the
lamellar grinding wheel
Right-angled alignment of
the cutting tool with the
lamellar grinding wheel
Cutting tool blade
Positioning angle for the
cutting tool blade
7
31