Changing The Grinding Belt (Sm-100/-100W) - Dick SM-100 Operating Instructions Manual

8
Servicing and Maintenance

8.2 Changing the grinding belt (SM-100/-100W)

Change the grinding belt as soon as it has become blunt (interval approx.
30–50 grinding operations). To replace, proceed as follows:
Figure 18 – Grinding arm
1
Figure 19 – Changing the grinding belt
Undo the fastening screws [18-2] of the right-hand side panel [18-1].
1. Push the side panel [18-1] to the rear and remove.
2. Push the clamping lever [19-2] in the direction of the arrow [19-3] to relax
it.
3. Remove the grinding belt [19-1].
4. Put on the new grinding belt so that the direction of rotation indication on
the grinding belt [19-4] matches the direction of rotation of the machine.
5. Mount the individual parts in reverse order.
6. Check the belt run and readjust if necessary.
36 Operating Instructions SM-90/-100/-100W
1
2
2
3
4
[18-1] Right-hand side panel
[18-2] Fastening screws
[19-1] Grinding belt
[19-2] Clamping lever
[19-3] Direction: Relax the
clamping lever
[19-4] Direction of rotation
indication on the grinding
belt