Dick SM-100 Operating Instructions Manual page 26

6
Putting the Machine into Operation
Switch on the machine as follows:
1. Check the belt run (SM-100/-100W only – see 6.5 Adjusting the belt run
(SM-100/-100W))
2. Insert the plug into the socket.
3. Press the green button [9-2] at the switch.
4. Compare the direction of rotation with the arrow on the cover.
If the direction of rotation does not match the direction of the arrow,

switch off the machine and contact the service department.
5. In case of deviations in the belt run, fine-tune it.
26 Operating Instructions SM-90/-100/-100W
RISK OF INJURY WHEN TOUCHING ABRASIVES
Touching the grinding belt, the lamellar grinding wheel, or the
polishing wheel when the machine is switched on will cause in-
juries.
Do not touch any abrasives while the machine is switched on.

Do not use any objects to brake rotating abrasives.

When switched on, the machine must be inaccessible to per-

sons not working at the machine, especially to children.
Before leaving the work area, switch off the machine and

disconnect the mains plug from the socket.
Do not touch rotating machine parts.

RISK OF INJURY DUE TO UNSUITABLE CLOTHING
AND LACK OF PROTECTIVE EQUIPMENT
Rotating machine parts can catch unsuitable clothing or long
hair and rotating abrasives can tear clothing. Flying abrasive
particles can damage the eyes and loud machine noise can
damage the ears. Sharp or hot cutting tools can cause injuries to
the hands.
Wear tight-fitting clothing.

Remove jewellery.

Wear a hair net on long hair.

Wear safety goggles and hearing protection.

Wear suitable protective gloves.

CAUTION
WARNING