Precautions When Working With Batteries - Xantrex Freedom X 1200 Owner's Manual

Precautions When Working With Batteries

Precautions When Working With
Batteries
IMPORTANT: Battery work and maintenance must be done by
qualified personnel knowledgeable about batteries to ensure
compliance with battery handling and maintenance safety
precautions.
BURN FROM HIGH SHORT-CIRCUIT CURRENT, FIRE
AND EXPLOSION FROM VENTED GASES HAZARDS
Always wear proper, non-absorbent gloves, complete eye
l
protection, and clothing protection. Avoid touching your
eyes and wiping your forehead while working near
batteries. See note #4.
Remove all personal metal items, like rings, bracelets, and
l
watches when working with batteries. See notes #5 and #6
below.
Never smoke or allow a spark or flame near the engine or
l
batteries.
Never charge a frozen battery.
l
Never charge a Lithium Ion type battery with an ambient of
l
0 °C (-32 °F) or colder.
Failure to follow these instructions can result in death, serious
injury, or equipment damage.
10
WARNING
NOTES:
1. Mount and place the Freedom X 1200 -120V Sine Wave
Inverter unit away from batteries in a well ventilated
compartment.
2. Always have someone within range of your voice or close
enough to come to your aid when you work near a lead-acid
battery.
3. Always have plenty of fresh water and soap nearby in case
battery acid contacts skin, clothing, or eyes.
4. Keep battery terminals clean from corrosion. If battery acid
or corrosion deposit contacts skin or clothing, wash
immediately with soap and water. If battery acid or corrosion
deposit enters your eye, immediately flood it with running
cold water for at least twenty minutes and have someone
within range of your voice or close enough to get medical
attention immediately.
5. Use extra caution to reduce the risk of dropping a metal tool
on the battery. It could spark or short circuit the battery or
other electrical parts and could cause an explosion. Use
tools with insulated handles only.
6. Batteries can produce a short circuit current high enough to
weld a ring or metal bracelet or the like to the battery
terminal, causing a severe burn.
7. When removing a battery, always remove the negative
terminal from the battery first for systems with grounded
negative. If it is grounded positive, remove the positive
terminal first. Make sure all loads connected to the battery
and all accessories are off so you don't cause an arc.
Freedom X 1200 Owner's Guide