Advantech AIWireless AIW-356 DQ-JK1 User Manual page 42

3.7. Interrupt Controls
AIW-356 DQ-JK1 module provides 3 interrupt signals, and the pin definition is as follows:
Pin Pin Name
8 W_DISABLE1#
25 DPR
26 W_DISABLE2#
Table 3-19 Interrupt control signal
3.7.1. W_DISABLE
The module provides a hardware pin to enable/disable WWAN RF function. Set
AT+GTFMODE=1 to enable this pin and the function can also be controlled by the AT
command. The module enters the Flight mode after the RF function is disabled. The definition
of W_DISABLE1# signal is as below table:
W_DISABLE1#
Signal
High/Floating
Low
Table 3-20 W_ DISABLE1# signal function definition
The module provides a hardware pin to enable/disable GNSS function, as listed in the
following table.
W_DISABLE2# Signal
High/Floating
Low
Table 3-21 W_ DISABLE2# signal function definition
I/O Reset Value Pin Description
Disable flight mode of the
I PU
WWAN module. Active low.
Dynamic power control for
I PU SAR interrupt detection,
active low. Reserved
I PU Disable GNSS. Active low
Function
WWAN function is enabled, and the module exits the Flight mode.
WWAN function is disabled, and the module enters Flight mode.
Function
Enable GNSS
Disable GNSS
Type
1.8V/3.3V
1.8V/3.3V
1.8V/3.3V
42