Elcometer SAGOLA 4000 Instruction Manual page 22

an Elcometer company
04. Components
01 Pressure regulator control
02 Device anchoring support
03 Air inlet
04 Air outlet (s)
05 Manometer
06 Automatic purge
07 Semi-automatic purge
08 Cup
09 Sintered bronze filter
10 Coalescent filter
05
05. Warnings
Before putting the unit into operation, and especially after each cleaning and/or repair
operation, a check must be made that the gun components are securely tightened and
that the air and/or product hoses are airtight (no air leaks). Faulty parts must be replaced or
repaired as appropriate.
The unit is easy to handle thanks to its design and the simplicity of its mechanisms. No special
training is required for handling the unit. Use it according to the operating, maintenance and
safety instructions indicated in this manual.
Before putting the unit into operation, we recommend you to clean the equipment as it has
been subjected to functional tests and before packaging it is treated internally with a protective
coating, some of which may still remain. Remove any residual grease applied during assembly.
Do not use corrosive or abrasive products
The unit has been designed for long service. If you need to apply special products, please
contact SAGOLA S.A.U.
Read and apply all the information, instructions and safety measures indicated by the
manufacturer of the products to be applied (thinners, etc.) as these may provoke chemical
reactions, fires and/or explosions, or be toxic, irritant or harmful and in all cases
dangerous for the health and personal safety of the user and of other persons nearby
(see chapter on Safety and Health).
EN 22
01
03
09
06
02
10
07
www.sagola.com
04
08