Appendix B Summary Table Of Communications/Output Settings - Emerson Rosemount 3410 Series Retrofit Instructions

Retrofit Instructions
00825-0300-3240
B Summary table of communications/
output settings
Based on switch position on the 3400 CPU board and Option board if installed, indicate
the appropriate configuration for each communication/output parameters on the 3400
electronics. Use these parameters to configure the 3410 Series electronics.
Table B-1: Communications/Output Settings Summary Table
Output
type
Serial
port A
Serial
port B
Serial
port C
Digital
output
1A
Digital
output
1B
Freque
ncy
output
1A
Digital
output
2A
Digital
output
2B
Freque
ncy
output
1B
Freque
ncy
output
2A
Emerson.com
(Check electronics switch settings and circle appropriate box for
each output)
Not RS-232 (if S3 is
used (if set to RS232)
J6 not
used)
Not RS-232 (if S4 is
used (if set to RS232)
J7 not
used)
Not RS-232 (if S10 is
used (if set to RS232)
J16 not
used)
Not TTL (if S8-1 is set
used (if to TTL)
J4-2 not
used)
Not TTL (if S8-2 is set
used (if to TTL)
J4-1 not
used)
Not TTL (if S8-3 is set
used (if to TTL)
J4-1 not
used)
Not TTL (if S9-1 is set
used (if to TTL)
J5-2 not
used)
Not TTL (if S9-2 is set
used (if to TTL)
J5-2 not
used)
Not TTL (if S8-4 is set
used (if to TTL)
J5-1 not
used)
Not TTL (if S9-3 is set
used (if to TTL)
J5-6 not
used)
Summary table of communications/output settings
RS-485 Half RS-485 Full
Duplex (if S3 is Duplex (if S3 is
set to RS-485 and set to RS-485 and
S5-1 is set to Half S5-1 is set to Full
RS-485 Half RS-485 Full
Duplex (if S4 is Duplex (if S4 is
set to RS482 and set to RS-485 and
S5-2 is set to S5-2 is set to Full)
Half)
RS-485 Half
Duplex (if S10 is
set to RS-485)
Open Collector (if
S8-1 is set to OC)
Open Collector (if
S8-2 is set to OC)
Open Collector (if
S8-3 is set to OC)
Open Collector (if
S8-1 is set to OC)
Open Collector (if
S9-2 is set to OC)
Open Collector (if
S8-4 is set to OC)
Open Collector (if
S9-3 is set to OC)
February 2024
55