Cleaning - Compak i3 Touch User Manual

10.1. GENERAL CLEANING
10.1.1 To ensure that the grinder functions
properly, and produces the highest quality grind
possible, the parts that come into contact with
coffee should cleaned periodically.
General Cleaning guidelines as follows:
•
Always turn the main power switch to the
off position ( ).
•
Unplug the machine from the power
source.
•
Do not submerge the grinder in water or
use power washing devices.
•
The appliance is not to be cleaned with a
water jet.
10.2. BEAN HOPPER CLEANING
10.2.1 In order to properly clean the bean
hopper ( ), first empty out all remaining beans
and fragments.
To remove the hopper, first close the bean trap
( ), and then loosen the hopper lock screw
( ) and lift the hopper straight up.
Clean the hopper ( ) with a moist soft cloth or
with a small amount of water and neutral soap
to eliminate any oily residue from the beans.
Replace the bean hopper (
same steps as the removal process, but in
reverse.
K09659H01 | PROC-CAL/002/03 USER MANUAL | V. 06/09/2023
10.3.
10.3.1 Compak recommends that the grind
chamber be cleaned monthly with a cleaner .
This process will eliminate smelly residues from
the coffee remains, which can negatively affect
the quality of the brewed coffee.
Care is needed when handling cutting burrs
during cleaning
The steps to follow are:
In order to properly clean the bean hopper
(
fragments.
•
•
•
•
•
) following the
•
•
10.
CLEANING THE GRIND CHAMBER
), first empty out all remaining beans and
Close the bean trap on the hopper (
and grind out the remaining coffee in the
grind chamber.
Pour the recommended grinder cleaning
product into the bean hopper (
open the bean trap (
cleaning product to pass into the grind
chamber.
Grind the cleaning product at a
medium coarse grind setting until the
recommended amount is passed through
the system and nothing remains in the
grind chamber.
Clean the hopper (
coffee beans.
Discard the first 2-3 doses of coffee to assure
that the residual cleaning product is removed
from the grind chamber and set the grind
regulator to the desired setting ( ).
Following these steps will ensure that the
grinder is clean and ready for use.
We do not recommend the taking apart
of the grind assembly unless changing
burrs, or removing a blockage/obstruction
in the grind chamber. Removal of the
grind assembly should be performed by a
qualified service technician.

CLEANING

)
) and
), allowing the
) and refill with
13