Appendix A: Restoring Factory Default Settings - ControlByWeb WEBRelay-10+ User Manual

Appendix A: Restoring Factory Default Settings

In the event that the IP address or passwords are forgotten, WebRelay-10 Plus™ may be restored to its original
factory default settings.
1. Remove the DC power from the unit. This will also de-energize any relay coils.
2. Use a thin, non-conductive object (such as a toothpick) to press and hold the small button located next to
the RJ-45 connector and Ethernet port. When the object is inserted, a tactile feedback can be felt as the
button is pressed.
CAUTION: DO NOT USE METAL OBJECTS FOR THIS FUNCTION.
3. While depressing the button, the green and yellow network LEDs will flash, apply power and wait for about
10 seconds before releasing the button. All settings will be back to the original factory defaults. log.txt and
syslog.txt are retained.
4. Refer to Section 2.3 Establishing Communications for Setup to begin reconfiguration of the device.
Figure Appendix A.1 - Restore Factory Defaults
Xytronix Research & Design, Inc.
WebRelay-10 Plus™ Users Manual
Page 21