Configuring The Device; Accessing The Compactflash Card - Siemens SIMATIC NET RUGGEDCOM MX5000RE Installation Manual

Device Management
3.2 Configuring the Device
The management port is a 10/100Base-TX copper Ethernet port with an RJ45
connector. The following is the pin-out for the management port:
8
Figure 3.2
Communication Ports
Connect any of the available Ethernet ports on the device to a management
switch and access the RUGGEDCOM MX5000RE console and Web interfaces via the
device's IP address. The factory default IP address for the RUGGEDCOM MX5000RE is
https://192.168.0.2.
For more information about available ports, refer to
Note
Single-mode fiber ports only support Ultra Physical Contact (UPC) cable connectors.
3.2

Configuring the Device

Once the device is installed and connected to the network, it must be configured.
All configuration management is done via the RUGGEDCOM MX5000RE interface.
For more information about configuring the device, refer to the RUGGEDCOM ROX
Configuration Manual associated with the installed software release.
3.3

Accessing the CompactFlash Card

The RUGGEDCOM MX5000RE features a removable CompactFlash (CF) card that
stores configuration files, firmware (active and backup versions), file-based feature
keys and other system files.
Configuration hazard – risk of data corruption/loss
Do not remove or insert the CF card when the device is powered on.
The CF card should only be removed in the following scenarios:
•
30
RJ45 Management Port
NOTICE
The chassis is defective (with the exception of power and media modules)
1
Pin Name
1 TX+ Transmit Data+
2 TX- Transmit Data-
3 RX+
4 Reserved (Do Not Connect)
5 Reserved (Do Not Connect)
6 RX-
7 Reserved (Do Not Connect)
8 Reserved (Do Not Connect)
"Modules (Page 33)".
Installation Manual, 01/2021, C79000-G8976-1060-13
Description
Receive Data+
Receive Data-
RUGGEDCOM MX5000RE