BD Alaris Directions For Use Manual page 9

Note: The single and dual channel Alaris™ SE Pump can be connected to the serial interface of the Workstation however
can not be fitted onto the MDI tile .
Note: All Pumps listed under 'Legacy Pumps' activate the Pump Alarm Location Beacon for high, medium, and low
priority alarms, where applicable . Refer to each Pump's Directions For Use for alarm information . The legacy
Alaris™ GW Volumetric Pump and the Alaris™ GW 800 Volumetric Pump exhibit the following differences in
behaviour for the Pump Alarm Location Beacon:
Condition
End of Infusion (KVO enabled)
End of Infusion (KVO disabled)
Low Battery
Attention
To access and configure the software installed on the Workstation, use a standard Web browser and an Ethernet
connection either over a network or by directly linking to the Workstation from a client PC .
The Workstation Web Browser User Interface is validated on Windows Internet Explorer 10 .
The software is provided under and is subject to a licence from BD .
Legacy Alaris™ GW Volumetric
Pump
Alarm Location Beacon
Behaviour
Yellow Beacon in KVO Phase
None
Yellow Beacon
None
BDDF00794 Issue 4
Alaris™ Gateway Workstation v1.3.x
Alaris™ GW 800 Volumetric Pump
Alarm Location Beacon
Behaviour
None for KVO Phase
Red Beacon
Red Beacon
Red Beacon
8/46
Introduction