Table of Contents
Advertisement
Maintenance
Routine Maintenance Procedures
To ensure that this Workstation remains in good operating condition, it is important to keep it clean and carry out the
routine maintenance procedures described below . All servicing should only be performed by Qualified Service Personnel
with reference to the Technical Service Manual (BDTM00004) .
Circuit diagrams, components parts lists and all other servicing information which assists the Qualified Service Personnel in
performing repair of the parts designated as repairable, are available upon request from BD .
If the Workstation is dropped, damaged, subjected to excessive moisture or high temperature,
immediately take it out of service for examination by Qualified Service Personnel.
All preventative and corrective maintenance and all such activities shall be performed at a compliant
work place in accordance with the information supplied. BD are not responsible should any of these
actions be performed outside the instructions or information supplied by BD. For Preventative and
Corrective Maintenance instructions, refer to the Technical Service Manual (TSM).
All preventative and corrective maintenance and all such activities should be performed by Qualified
Service Personnel only, with reference to the TSM.
Interval
Routine Maintenance Procedure
When loading
Check that each Pump is properly located on the MDI and is mechanically locked into position .
Pumps
When removing
Check that the MDI Warning LED turns off when the Pump is removed . If the LED stays on, the
Pumps
Workstation should be serviced by Qualified Service Personnel .
As per Hospital
Thoroughly clean external surfaces of the equipment before and after prolonged periods of
Policy
storage .
At least once per
• Inspect AC outlets, communication connectors and the AC inlet for damage .
year
• Perform electrical safety checks . The complete unit earth leakage current must be measured . If
(Refer to TSM for
more than 5mA, the equipment should not be used, but should be serviced by Qualified Service
identification of
Personnel .
parts)
Battery
It is recommended that only Qualified Service Personnel replace the battery, using only a BD recommended battery .
For further information regarding the replacement of batteries refer to the Technical Service Manual .
The battery pack used in this Alaris™ Gateway Workstation is manufactured by BD and includes a proprietary PCB
(printed circuit board) designed specifically for the Alaris™ Gateway Workstation, and in conjunction with Alaris™ Gateway
Workstation software, controls battery use, charge and temperature . Any use of battery packs that are not manufactured
by BD in the Alaris™ Gateway Workstation is at your sole risk, and BD does not provide any warranty for or endorsement
on any battery packs that are not manufactured by BD . BD product warranty shall not apply in the event the Alaris™
Gateway Workstation has suffered damage or premature wear, or malfunctions or otherwise operates incorrectly, as a
result of use with a battery pack that is not manufactured by BD .
Replacing the AC Fuses
If the AC power indicator does not illuminate when the Workstation is connected to the AC power supply, either the power
supply fuse in the AC plug or, the AC fuses of the Workstation have blown .
First check the power supply fuse in the AC plug, if the AC power indicator does not illuminate proceed to check the
Workstation AC fuses . Switch the power off and disconnect the Workstation from the AC power supply .
It is recommended that only Qualified Service Personnel replace the AC fuses . For further information regarding the
replacement of internal AC fuses refer to the Technical Service Manual .
If the fuses continue to blow, suspect an electrical fault and have the Workstation and power supply
checked out by Qualified Service Personnel.
BDDF00794 Issue 4
Alaris™ Gateway Workstation v1.3.x
41/46
Maintenance
Advertisement
Table of Contents
