Infusion Line Tidies (Where Fitted); Alaris™ Gateway Workstation Trolley - BD Alaris Directions For Use Manual

Infusion Line Tidies (where fitted)

To assist in the routing of infusion sets and syringe extension sets from the Pumps to the patient, line tidies can be
attached to the rear of the Workstation . The infusion line tidies are height adjustable allowing positioning adjacent to
both syringe and volumetric Pumps, and may be mounted on the left or right hand side of the Workstation . To use the
infusion line tidies:
1 . Loosen the hand wheel and adjust to the desired position .
2 . Hand tighten the hand wheel to secure the device .
3 . Refit rubber strip .
Note: It is recommended that line tidies be used to organize the infusion lines, this could
reduce the risk of tangled infusion lines and tripping the user or patient .
Alaris™ Gateway Workstation Trolley
When the Workstation is mounted to the Alaris™ Gateway Workstation Trolley and is not being transported, the brakes
should be engaged .
To operate the Alaris™ Gateway Workstation Trolley brakes:
1 . Locate brake mechanism at the end of the wheels .
2 . Press down to engage the brakes .
All wheels that have brakes should be set to the same engaged or disengaged state.
Prior to moving the Alaris™ Gateway Workstation Trolley all brakes should be disengaged.
Bottom up view, showing four locking casters:
New Alaris™ Gateway Workstation Trolleys shipped with Workstation of version 1.3.x or higher are
equipped with four locking casters.
3 . Pull up to disengage the brakes .
BDDF00794 Issue 4
Alaris™ Gateway Workstation v1.3.x
Features of the Workstation
18/46