Power Over Ethernet (Poe) Pse - Advantech ICR-4401 Hardware Manual

2. Hardware Functionality

2.3 Power over Ethernet (PoE) PSE

Available only for models with the PoE PSE feature; see Chapter
The router supports the IEEE 802.3af/PoE (Type 1) and IEEE 802.3at/PoE+ (Type 2) standards and is
Mode B compliant.
To control the PoE functionality, you can use the pse command. For detailed information, please refer to
the Commands and Scripts
Please note that the router's power supply must be 48 V DC to operate as the PoE PSE device.
The PoE PSE feature enables the router to provide power to other devices over the Ethernet socket. You
can refer to the functional scheme in Figure 10.
The PoE PSE feature is supported by all four ETH0 network sockets and can be individually enabled in
the Ethernet configuration pages. Detailed instructions can be found in the router configuration manual [1],
specifically in Chapter Configuration
pinout, please refer to Chapter 2.2.
To monitor the current PoE state, navigate to the General status page in the GUI. When PoE is enabled
and an external device is being powered, you can access information about current, voltage, power, and
power class here.
ICR-4401 Hardware Manual
application note.
Figure 10: PoE PSE Funcional Scheme
Ethernet Configuration. For information about the Ethernet socket
2.3 Power over Ethernet (PoE) PSE
1.3 for the order codes.
13