Table of Contents
Advertisement
2.4 Power over Ethernet (PoE) PSE
Available only for models with the PoE PSE feature; see Chapter
The router supports the IEEE 802.3af/PoE (Type 1) and IEEE 802.3at/PoE+ (Type 2) stan-
dards and is Mode B compliant.
To control the PoE functionality, you can use the pse command. For detailed information,
please refer to the
Commands and Scripts
Please note that the router's power supply must be 48 V DC to operate as the PoE PSE
device.
The PoE PSE feature enables the router to provide power to other devices over the Ether-
net socket. You can refer to the functional scheme in Figure 14.
The PoE PSE feature is supported by all four ETH0 network sockets and can be individually
enabled in the Ethernet configuration pages. Detailed instructions can be found in the router
configuration manual [1], specifically in Chapter Configuration -> Ethernet Configuration. For
information about the Ethernet socket pinout, please refer to Chapter 2.3.
To monitor the current PoE state, navigate to the General status page in the GUI. When
PoE is enabled and an external device is being powered, you can access information about
current, voltage, power, and power class here.
application note.
Figure 14: PoE PSE Funcional Scheme
17
ICR-4461
1.4
for the order codes.
Advertisement
Table of Contents
