Remote Thermostat Wiring - Afg Pro-2.0 - QuietCool AFG PRO-2.0 Owner's Manual

5. Tie the black wire from the power source to the remaining black wire from the thermostat.
6. Using the ground screw in the thermostat, ground your power source and the green wire from
the fan.
7. Mount the thermostat to one of the joists near the attic fan.
Figure 3.1A
Specialty Series Fan
Power Source
Figure 3.1B
Specialty Series Fan
3.2 REMOTE THERMOSTAT WIRING
1. For this installation, you will need a 2 wire Romex, junction box, and a thermostat.
2. Open up the thermostat that is connected to the fan. Remove the power cord. Remove the bracket
mounting the thermostat to the flex tubing and remove the thermostat. Mount a junction box to
the flex tubing with the included bracket and mount the junction box. Bring your 2 wire romex from
the power source into the junction box.
3. Mount the thermostat in the best location for thermostat readings. Run a 2 wire Romex from the
junction box to the thermostat. Tape the white wire on each side of the 2 wire Romex to indicate that
it is a switch leg.
8
Low Speed
High Speed
Ground the fan and power to the thermostat
using the green ground screw
14-2 Wire
2 Wire Romex
Low Speed
High Speed
Ground the fan and power to the thermostat
using the green ground screw
14-2 Wire
2 Wire Romex
Power Source
Thermostat
Thermostat
60°
1-888-QUIETCOOL