Memory Operation; Qmb Channel - Yaesu FT-817ND Operating Manual

M
EMORY
QMB Channel Storage
1. Tune in the desired frequency and set the operating mode and bandwidth. If this is an FM
channel, set up any required CTCSS/DCS and repeater shift configurations.
2. Press and hold in the
audible confirmation that the data has been stored into the QMB memory.
Pressing the
RCL, PMS ] will also store a frequency into the QMB register.
QMB Channel Recall
1. Press the key momentarily, then rotate the
Function Row 3 [ STO, RCL, PMS ] appears on the display.
( RCL ) key momentarily to recall the QMB memory. "QMB" will appear at
2. Press the
the upper right corner on the LCD.
( RCL ) key once more to return to the previous frequency (either a VFO
3. Press the
frequency or a Memory channel).
If you move the
change frequencies as if you were in a "VFO" mode. You also can change operat-
ing mode by pressing the
will appear in the display, where "MT" represents "Memory Tuning." Press the
key once more to return to the originally-stored QMB frequency.
44
O
PERATION
QMB C
key until a double "beep" is heard. The second beep provides
( A/B ) key momentarily while in Operating Function Row 3 [ STO,
knob or
or
HANNEL
knob, as needed, until Operating
knob while in the QMB mode, you can
key. When this is done, the "MTQMB"
FT-817
( RCL )
Operating Manual