Table of Contents
Advertisement
414 Technical data
E 350, E 350 4MATIC: use only SAE 0W-20 vis-
cosity class engine oils.
%
If the engine oils listed in the table are not
available, you may add a maximum of
1.1 US qt (1.0 liter) of the following engine
oils once only.
MB-Freigabe or MB-Approval 229.51, 229.52,
229.61 or ACEA C5
Engine oil filling capacity
Model
Capacity
E 450 4MATIC
10.5 US qt (9.9 liters)
All other models
6.3 US qt (6.0 liters)
The specified filling capacity refers to an oil
change with the oil filter.
Notes on brake fluid
Observe the notes on operating fluids
(
page 410).
/
& WARNING Risk of an accident due to
vapor pockets forming in the brake system
The brake fluid constantly absorbs moisture
from the air. This lowers the boiling point of
the brake fluid. If the boiling point is too low,
vapor pockets may form in the brake system
when the brakes are applied hard.
This causes the braking effect to be impaired.
Have the brake fluid renewed at the
#
specified intervals.
Have the brake fluid regularly replaced at a quali-
fied specialist workshop.
Only use a brake fluid approved by Mercedes-
Benz according to MB-Freigabe or MB-Approval
331.0.
Coolant
▌Notes on coolant
Observe the notes on operating fluids
(
page 410).
/
& WARNING ‑ Risk of fire and injury from
antifreeze
If antifreeze comes into contact with hot com-
ponent parts in the engine compartment, it
may ignite.
Allow the engine to cool down before
#
adding antifreeze.
Make sure that no antifreeze spills out
#
next to the filler opening.
Thoroughly clean off any antifreeze from
#
component parts before starting the
vehicle.
* NOTE Damage caused by incorrect cool-
ant
Only use coolant that has been premixed
#
with the required antifreeze protection.
Information on coolant is available at the fol-
lowing locations:
In the Mercedes-Benz Specification for
R
Operating Fluids 320.1
Advertisement
Table of Contents
