Table of Contents
Advertisement
Before loading the vehicle, wait until the trans-
#
port level has been reached and the
port Level
status is shown.
%
If the vehicle is raised to transport level, the
transport settings will continue to be shown
even after a restart. Operation of the driver's
display will be restricted.
When the vehicle is at transport level, it will be
lowered again in the following situations:
When driving faster than 25 mph (40 km/h).
R
The 12V battery is discharged.
R
The vehicle will be adjusted to the height of the
last active level.
Transporting the vehicle
Load the vehicle onto the transporter.
#
Shift the transmission to position j.
#
Use the electric parking brake to secure the
#
vehicle against rolling away.
Switch off the vehicle and the power supply.
#
Only secure the vehicle by the wheels.
#
4MATIC vehicles
Trans-
Make sure that the front and rear axles come
#
to rest on the same transportation vehicle.
* NOTE Damage to the drive train due to
incorrect positioning of the vehicle
Do not position the vehicle above the
#
connection point of the transport vehi-
cle.
Unloading the vehicle
Make sure that the vehicle is raised to trans-
#
port level before unloading
(
page 367, 369).
/
Breakdown assistance 369
Lowering the vehicle after unloading
Switch on the power supply.
#
Start the vehicle.
#
In the transport settings, swipe up to select
#
the
Standard Level
and press a.
The vehicle will be adjusted to the height of
the last active level and the
Lowering Vehi-
cle...
message will be displayed.
After the vehicle has been lowered, press the
#
G button for at least two seconds.
The transport settings will close.
Loading the vehicle for transportation (vehicles
without AIRMATIC)
Observe the notes on towing away.
#
Connect the towing device to the towing eye
#
in order to load the vehicle.
Shift the automatic transmission to position
#
i.
Advertisement
Table of Contents
