Table of Contents
Advertisement
To protect against overheating, the seat heating
may be temporarily deactivated after it has been
switched on repeatedly.
%
This function is available only for vehicles with
48 V on-board electrical systems.
The air inside the vehicle can be heated, ventila-
ted or cooled to the set temperature when the
vehicle is parked.
When the vehicle is connected to power supply
equipment, priority will be given to charging the
48 V battery to a specified minimum state of
charge.
The running time of pre-entry climate control may
be reduced under the following conditions:
The vehicle is not connected to power supply
R
equipment.
The 48 V battery is not fully charged.
R
With active pre-entry climate control, the state of
charge of the 48 V battery may be reduced, even
if the charging cable connector is connected.
If present, seat ventilation will be activated in
cooling and ventilation modes.
Depending on the vehicle's equipment, the follow-
ing functions will be activated in heating mode, if
available:
Seat heating
R
Steering wheel heating
R
Panel heating
R
Mirror heater
R
Rear window defroster
R
When the set temperature changes, climate con-
trol mode will switch automatically as follows:
From heating mode to ventilation or cooling
R
mode, or
From cooling mode to ventilation or heating
R
mode, or
From ventilation mode to heating or cooling
R
mode
Climate control 165
▌Setting pre-entry climate control at departure
time via the multimedia system
Multimedia system:
Climate Menu
Pre-entry Climate Ctrl.
4
5
Setting the departure time
Select
Edit Departure Time
´ .
#
Select a departure time or set a new depar-
#
ture time.
Setting the repeat days
Edit Departure Time
´ .
Select
#
Set the desired departure time and select the
#
corresponding weekdays on which this depar-
ture time is to apply.
Press
OK
to confirm.
#
Selecting seats
Select Driver, Passenger,
Rear Left
#
Right.
Pre-entry climate control will take place for
the selected seats.
or
Rear
Advertisement
Table of Contents
