Table of Contents
Advertisement
Adaptive Highbeam Assist Plus automatically
switches between the following types of light:
Low beam
R
Partial high beam
R
High beam
R
ULTRA RANGE Highbeam
R
ULTRA RANGE Highbeam increases the bright-
ness of the cone of light close to the legally per-
mitted maximum.
Partial high beam does not include other road
users in the high beam area. It does not dazzle
them but enables full high-beam illumination for
the driver apart from the excluded vehicles. Highly
reflective signs are also illuminated with reduced
brightness.
At speeds below 16 mph (25 km/h) or when
there is sufficient street lighting:
Partial high beam and high beam will be
R
switched off automatically.
At speeds above 19 mph (30 km/h):
If no other road users are detected, high beam
R
will be switched on automatically.
If other road users are detected, partial high
R
beam will be switched on automatically.
at speeds below 25 mph (40 km/h):
ULTRA RANGE Highbeam will switch off auto-
R
matically.
Light and visibility 145
At speeds above 31 mph (50 km/h):
If no other road users are detected, the road is
R
straight and it is not raining heavily, ULTRA
RANGE Highbeam will be switched on auto-
matically.
If other road users are detected, partial high
R
beam will be switched on automatically.
If highly reflective signs are detected, ULTRA
R
RANGE Highbeam will be switched off auto-
matically.
%
The system's optical sensor is located behind
the windshield near the overhead control
panel.
▌Switching Adaptive Highbeam Assist Plus
on/off (Canada)
Switching on
Turn the light switch to the à position.
#
Switch on high beam using the combination
#
switch.
If Adaptive Highbeam Assist Plus is activated,
the _ indicator lamp will light up on the
driver's display. When partial high beam or
Advertisement
Table of Contents
