Electrolux LKI66890SW User Manual page 41

Problem
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The lamp does not oper‐
ate.
The core temperature sen‐
sor does not operate.
It takes too long to cook
the dishes or they cook too
quickly.
Steam and condensation
settle on the food and in
the cavity of the oven.
The oven display shows
"C2".
The oven display shows
"F102".
The oven display shows
"00:00".
The display shows an error
code that is not in this ta‐
ble.
Possible cause
The necessary settings are
not set.
The automatic switch-off is
activated.
The Child Lock is on.
The lamp is defective.
The plug of the core tem‐
perature sensor is not cor‐
rectly installed into the
socket.
The temperature is too low
or too high.
You left the dish in the
oven for too long.
You want to start the Pyrol‐
ysis or Fast Heat UpDe‐
frost function, but you did
not remove the core tem‐
perature sensor plug from
the socket.
• You did not fully close
the door.
• The door lock is defec‐
tive.
There was a power cut.
There is an electrical fault.
ENGLISH
Remedy
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".
Refer to "Using the Child
Lock".
Replace the lamp.
Put the plug of the core
temperature sensor as far
as possible into the socket.
Adjust the temperature if
necessary. Follow the ad‐
vice in the user manual.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
Remove the core tempera‐
ture sensor plug from the
socket.
• Fully close the door.
• Deactivate the oven
with the house fuse or
the safety switch in the
fuse box and activate it
again.
• If the display shows
"F102" again, contact
the Customer Care De‐
partment.
Set the time of day.
Deactivate the appliance
with the house fuse or the
safety switch in the fuse
box and activate it again. If
the display shows the error
code again, contact the
Customer Care Depart‐
ment.
41